Nissan Altima 2007-2012 Service Manual: Refrigeration system
HFC-134a (R-134a) Service Procedure
SETTING OF SERVICE TOOLS AND EQUIPMENT
WARNING: Avoid breathing the A/C refrigerant and oil vapor or mist. Exposure may irritate eyes, nose, and throat.
Remove the HFC-134a (R-134a) from the A/C system using certified service equipment meeting the requirements of SAE J2210 (R-134a recycling equipment) or SAE J2201 (R-134a recovery equipment).
If an accidental system discharge occurs, ventilate the work area before resuming service. Additional health and safety information may be obtained from the refrigerant and oil manufacturers.
Discharging Refrigerant
Evacuating System and Charging Refrigerant
Discharging, Evacuating, and Recharging the A/C System
*1 HA-21, "Maintenance of Oil Quantity in Compressor"
*2 HA-25, "Checking of Refrigerant Leaks"
*3 HA-25, "Checking of Refrigerant Leaks"
*4 HAC-5, "Operational Check"
*5 HA-4, "Contaminated Refrigerant"
Checking of Refrigerant Leaks
Perform a visual inspection of all refrigeration parts, fittings, hoses and components for signs of A/C oil leakage, damage and corrosion. A/C oil leakage may indicate an area of refrigerant leakage. Allow extra inspection time in these areas when using either an electronic refrigerant leak detector or fluorescent dye leak detector.
If dye is observed, confirm the leak with an electronic refrigerant leak detector. It is possible a prior leak was repaired and not properly cleaned.
When searching for leaks, do not stop when one leak is found but continue to check for additional leaks at all system components and connections.
When searching for refrigerant leaks using an electronic leak detector, move the probe along the suspected leak area at 25 - 50 mm (1 - 2 in) per second and no further than 6 mm (1/4 in) from the component.
CAUTION: Moving the electronic leak detector probe slower and closer to the suspected leak area will improve the chances of finding a leak.
Oil
Maintenance of Oil Quantity in Compressor The oil in the compressor circulates through the system with the refrigerant. Add oil to compressor when replacing any component or after a large refriger ...Fluorescent leak detector
Checking System for Leaks Using the Fluorescent Leak Detector 1. Check A/C system for leaks using the UV lamp and safety goggles (J-42220) in a low sunlight area (area without windows preferable ...Other materials:
P1574 ASCD vehicle speed sensor
Description
The ECM receives two vehicle speed signals via CAN communication line. One is
sent from combination
meter, and the other is from TCM (Transmission control module). The ECM uses
these signals for ASCD control.
Refer to EC-67, "System Description" for ASCD functions.
D ...
P0720 vehicle speed sensor cvt (secondary
speed sensor)
Description
The vehicle speed sensor CVT [output speed sensor (secondary speed sensor)]
detects the revolution of the
CVT output shaft and emits a pulse signal. The pulse signal is sent to the TCM,
which converts it into vehicle
speed.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCE ...
P2138 APP Sensor
Description
The accelerator pedal position sensor is installed on the upper end
of the accelerator pedal assembly. The sensor detects the accelerator
position and sends a signal to the ECM.
Accelerator pedal position sensor has two sensors. These sensors
are a kind of potentiometers which tr ...