Nissan Altima Owners Manual: Reprogramming a single HomeLink® button

To reprogram a HomeLink® Universal Transceiver button, complete the following: 1. Press and hold the desired HomeLink® button.

DO NOT release the button.

2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink® button, proceed with “Programming HomeLink®” - Step 1.

For questions or comments, contact HomeLink® at: www.homelink.com or 1–800–355–3515 (except Mexico).

The HomeLink® Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink® button that was just programmed. This procedure will not affect any other programmed HomeLink® buttons.

    Clearing the programmed information
    The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed. See “Reprogramming a single Ho ...

    If your vehicle is stolen
    If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink®. Consult the Owner’s Manual of each device or call the manufacturer ...

    Other materials:

    P0443 evap canister purge volume control solenoid valve
    Description The EVAP canister purge volume control solenoid valve uses a ON/ OFF duty to control the flow rate of fuel vapor from the EVAP canister. The EVAP canister purge volume control solenoid valve is moved by ON/OFF pulses from the ECM. The longer the ON pulse, the greater the amount o ...

    On-vehicle repair
    POWER SOCKET Removal and Installation FRONT POWER SOCKET Removal 1. Remove the instrument panel storage bin or CD changer finisher (if equipped). Refer to IP-17, "Exploded View". 2. Remove the inner socket (1) from the ring (2) while pressing the hooks (B) on the ring (2) out fr ...

    Camera image signal circuit (rear view camera to camera control unit)(coupe)
    Description Rear view camera images are transmitted to the rear view camera control unit using the camera image signal circuits. Diagnosis Procedure 1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect rear view camera control unit connector and rear v ...