Nissan Altima 2007-2012 Service Manual: Roof side molding

Removal and Installation

1. Body side outer panel

2. Windshield

2. Windshield

REMOVAL

1. Lift and twist the roof side molding up from the rear edge.

2. Disconnect the roof side molding from the clips, and remove the roof side molding.

INSTALLATION

Installation is in the reverse order of removal.

• Engage the roof molding into the clips starting at the rear.

    Drip molding
    Removal and Installation REMOVAL 1. Using a trim stick or equivalent, disconnect the drip mouldings starting at the front, working rearward. 2. Remove the drip moldings. INSTALLATION Ins ...

    License lamp finisher
    Removal and Installation 1. License lamp finisher REMOVAL 1. Remove the trunk lid finisher (if equipped). Refer to INT-22, "Exploded View". 2. Remove the license lamp finisher nuts ...

    Other materials:

    Audible reminders
    Brake pad wear warning The disc brake pads have audible wear warnings. When a disc brake pad requires replacement, it makes a high pitched scraping sound when the vehicle is in motion, whether or not the brake pedal is depressed. Have the brakes checked as soon as possible if the warning sou ...

    Camera image signal circuit (rear view camera to camera control unit)(coupe)
    Description Rear view camera images are transmitted to the rear view camera control unit using the camera image signal circuits. Diagnosis Procedure 1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect rear view camera control unit connector and rear v ...

    BCM (Body control module)
    Reference Value VALUES ON THE DIAGNOSIS TOOL Terminal Layout Physical Values 1: Sedan only 2: With LH front window anti-pinch 3: With LH and RH front window anti-pinch 4: With Intelligent Key 5: Without Intelligent Key Wiring Diagram-Coupe ...