Nissan Altima (L32) 2007-2012 Service Manual: Satellite radio tuner
Diagnosis Procedure
1.CHECK FUSES
Check that the following fuses are not blown.
Are the fuses OK? YES >> GO TO 2
NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
2.POWER SUPPLY CIRCUIT CHECK
1. Turn ignition switch OFF.
2. Disconnect satellite radio tuner (factory installed) connector B123.
3. Check voltage between the satellite radio tuner (factory installed) and ground.
Are the voltage results as specified? YES >> GO TO 3
NO >> • Check connector housings for disconnected or loose terminals.
• Repair harness or connector.
3.GROUND CIRCUIT CHECK
Inspect satellite radio tuner (factory installed) case ground.
Does case ground pass inspection? YES >> Inspection End.
NO >> Repair satellite radio tuner (factory installed) case ground.
Bose speaker AMP
Diagnosis Procedure 1.CHECK FUSE Check for blown fuses. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER ...Bluetooth control unit
Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the Bluetooth control unit are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause ...Other materials:
Precautions
Description
Observe the following precautions to ensure safe and proper servicing. These
precautions are not
described in each individual section.
Supplemental Restraint System (SRS) "AIR BAG"
and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR ...
Driver side
Description
Door glass moves UP/DOWN by receiving the signal from main power window and
door lock/unlock switch.
Component Function Check
1. CHECK POWER WINDOW MOTOR LH CIRCUIT
Does power window motor LH operate with the main power window and door
lock/unlock switch?
Is the inspectio ...
Spark plug
Removal and Installation
1. Ignition coil
2. Spark plug
3. Rocker cover
REMOVAL
1. Remove the ignition coil. Refer to EM-35, "Removal and Installation".
2. Remove the spark plug with a suitable spark plug wrench.
INSPECTION AFTER REMOVAL
• Do not use a wire brush for clean ...