Nissan Altima (L32) 2007-2012 Service Manual: Seat belt warning chime

11

System Diagram

System Description

DESCRIPTION

With ignition switch turned ON and driver seat belt unfastened, seat belt warning chime will sound for approximately 6 seconds.

• BCM receives seat belt buckle switch signal from combination meter with CAN communication line.

• BCM detects ignition switch turned ON and seat belt buckle switch LH ON. And then transmits buzzer output signal (seat belt warning chime) to combination meter with CAN communication line.

• When combination meter receives buzzer output signal (seat belt warning chime), it sounds the buzzer.

WARNING OPERATION CONDITIONS

If all of the following conditions are fulfilled

• Ignition switch OFF→ON

• Seat buckle switch LH is ON (driver seat belt not fastened)

WARNING CANCEL CONDITIONS

Cancels the warning if any of the following conditions is fulfilled.

• Ignition switch OFF

• Seat buckle switch LH is OFF (driver seat belt fastened)

• 90 seconds have passed since the start of the warning

Component Parts Location

1. Combination meter M24

2. Combination switch (lighting switch) M28

3. Seat belt buckle switch LH B202

4. Door switch LH B8

5. BCM M16, M17, M18, M19 (view with instrument panel removed)

6. ABS actuator and electric unit (control unit) E26

7. Parking brake switch M73 (sedan with M/T or coupe) (view with center console removed)

8. Parking brake switch E35 (sedan with CVT) [view with instrument panel lower cover (LH) removed]

Component Description

    Light reminder warning chime
    System Diagram System Description DESCRIPTION With ignition switch in OFF or ACC position, driver door open, and lighting switch in 1ST or 2ND position, the light warning chime will sound. ...

    Parking brake release warning chime
    System Diagram  System Description DESCRIPTION • The combination meter receives the vehicle speed signal from the ABS actuator and electric unit (control unit) via CAN communication l ...

    Other materials:

    Camera image signal circuit (camera control unit to av control unit)
    Description Rear view camera image signals are transmitted from the rear view camera control unit to the AV control unit using the image signal circuits. Diagnosis Procedure 1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect rear view camera control ...

    Rear-facing child restraint installation using the seat belts
    WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden stop o ...

    S Terminal circuit
    Description The output voltage of the generator is controlled by the IC regulator at terminal “3” (S) detecting the input voltage. Terminal “3” circuit detects the battery voltage to adjust the generator output voltage with the IC regulator. Diagnosis Procedure 1.CHECK VOLTAGE REG ...