Nissan Altima Owners Manual: Seats
WARNING
● Do not ride in a moving vehicle when the seatback is reclined. This can be dangerous. The shoulder belt will not be against your body. In an accident, you could be thrown into it and receive neck or other serious injuries. You could also slide under the lap belt and receive serious internal injuries.
● For the most effective protection when the vehicle is in motion, the seat should be upright. Always sit well back in the seat with both feet on the floor and adjust the seat properly. See “Precautions on seat belt usage” later in this section.
● After adjustment, gently rock in the seat to make sure it is securely locked.
● Do not leave children unattended inside the vehicle. They could unknowingly activate switches or controls. Unattended children could become involved in serious accidents.
● Do not adjust the driver’s seat while driving so full attention may be given to vehicle operation. The seat may move suddenly and could cause loss of control of the vehicle.
● The seatback should not be reclined any more than needed for comfort. Seat belts are most effective when the passenger sits well back and straight up in the seat. If the seatback is reclined, the risk of sliding under the lap belt and being injured is increased.
CAUTION
When adjusting the seat positions, be sure not to contact any moving parts to avoid possible injuries and/or damage.
- Front manual seat adjustment (if so equipped
- Front power seat adjustment (if so equipped for driver’s seat)
- Folding rear seat
- Front seat head restraints/headrests
- Rear seat head restraints/headrests
Front manual seat adjustment (if so equipped
Forward and backward Pull the center of the bar up and hold it while you slide the seat forward or backward to the desired position. Release the bar to lock the seat in position. Reclining T ...Other materials:
Antenna AMP
Removal and Installation - Coupe
REMOVAL
1. Remove the rear pillar finisher RH. Refer to INT-20, "Exploded View".
2. Detach the antenna amp harness clip (B), disconnect the
antenna amp connectors (A), remove the antenna amp screw
(C) and remove the antenna amp (1).
NSTALLATION
...
On board diagnostic (OBD) System
Diagnosis Description
INTRODUCTION
The ECM has an on board diagnostic system, which detects malfunctions related
to engine sensors or actuators.
The ECM also records various emission-related diagnostic information including:
The above information can be checked using procedures listed in ...
Audio antenna (sedan)
Location of Antenna
1. In-line connectors M87, M501
2. AV control unit harness
3. AV control unit
4. Satellite antenna
5. AV control unit antenna feeder
6. Satellite radio antenna feeder
7. Window Antenna
8. Antenna amp.
9. Satellite radio tuner
Window Antenna Repair
ELEMENT CHECK
1. ...