Nissan Altima 2007-2012 Service Manual: Secondary speed sensor

Exploded View

1. CVT assembly

2. Shims

3. O-ring

4. Secondary Speed Sensor

Removal and Installation

Refer to the figure for removal and installation. CAUTION: • Do not reuse O-ring.

• Apply CVT fluid to O-ring.

• Insert the shims.

• After installation is complete, check for CVT fluid leakage and CVT fluid level Refer to TM-416, "Inspection".

    Primary speed sensor
    Exploded View 1. CVT assembly 2. O-ring 3. Primary speed sensor Removal and Installation Refer to the figure for removal and installation. CAUTION: • Do not reuse O-ring. • Apply CVT ...

    Oil pump fitting bolt
    Exploded View 1. Oil pump fitting bolt 2. O-ring 3. CVT assembly Removal and Installation Refer to the figure for removal and installation. CAUTION: • Do not reuse O-ring. • Apply C ...

    Other materials:

    Interior room lamp
    Removal and Installation FRONT ROOM/MAP LAMP NOTE: For non-sunroof equipped vehicles, the front room/map lamp assembly is an integral part of the headinlining and repaired only as an assembly. Refer to INT-20, "Removal and Installation" for coupe models, and INT-42, "Removal ...

    POWER STEERING OIL PUMP
    Inspection RELIEF OIL PRESSURE CAUTION: Make sure that belt tension is normal before starting the following procedure. 1. Connect the Tool between oil pump discharge connector and high-pressure hose. Bleed air from the hydraulic circuit while opening valve fully. Refer to ST-8, "Inspectio ...

    P0868 secondary pressure down
    Description The pressure control solenoid valve B (secondary pressure solenoid valve) regulates the secondary pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe ...