Nissan Altima (L32) 2007-2012 Service Manual: Service data and specifications (SDS)
General Specification
CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluid.
• Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT, which is not covered by the NISSAN new vehicle limited warranty.
*1: Refer to MA-12, "Fluids and Lubricants".
Vehicle Speed When Shifting Gears
Numerical value data are reference values.
CAUTION: Lock-up clutch is engaged when vehicle speed is approximately 18 km/h (11 MPH) to 90 km/h (56 MPH).
Stall Speed
Line Pressure
Solenoid Valves
CVT Fluid Temperature Sensor
Primary Speed Sensor
Secondary Speed Sensor
Removal and Installation
Disassembly and assembly
TORQUE CONVERTER AND CONVERTER HOUSING OIL SEAL Exploded View 1. CVT assembly 2. Converter housing oil seal 3. Torque converter Apply CVT Fluid. Refer to MA-12, "Fluids and Lubricants& ...Front Axle
...Other materials:
Parking lamp circuit
Description
The IPDM E/R (intelligent power distribution module engine room) controls the
tail lamp relay based on inputs
from the BCM over the CAN communication lines. When the tail lamp relay is
energized, power flows through
fuses 46 and 47, located in the IPDM E/R. Power then flows to th ...
General maintenance
During the normal day-to-day operation of the
vehicle, general maintenance should be performed
regularly as prescribed in this section. If
you detect any unusual sounds, vibrations or
smells, be sure to check for the cause or have a
NISSAN dealer do it promptly. In addition, you
should notify ...
AV branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the AV control unit for damage, bend
and loose connection (unit
side and connector side).
I ...