Nissan Altima (L32) 2007-2012 Service Manual: Service data and specifications (SDS)
Standard and Limit
GENERAL SPECIFICATIONS
DRIVE BELTS
CYLINDER HEAD
* Approximately 80°C (176°F)
Available Valve Lifter
Valve Spring
CAMSHAFT AND CAMSHAFT BEARING
CYLINDER BLOCK
PISTON, PISTON RING, AND PISTON PIN
Available Piston
Piston Ring
CONNECTING ROD
CRANKSHAFT
*: Total indicator reading
MAIN BEARING
Undersize
CONNECTING ROD BEARING
Undersize
Bearing Clearance
FLYWHEEL
How to select piston and bearing
DESCRIPTION *For the service parts, the grade for fitting cannot be selected between a piston pin and a connecting rod. (Only 0 grade is available.) The information at the shipment from the pl ...Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER ...Other materials:
P1421 Cold start control
Description
ECM controls ignition timing and engine idle speed when engine is started
with prewarming up condition.
This control promotes the activation of three way catalyst by heating the
catalyst and reduces emissions.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P1421 is displayed wit ...
P0144 HO2S3
Description
The heated oxygen sensor 3, after HC adsorption catalyst (Under
floor), monitors the oxygen level in the exhaust gas on each bank.
This sensor is made of ceramic zirconia. The zirconia generates voltage
from approximately 1V in richer conditions to 0V in leaner conditions.
Unde ...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Trouble Diagnosis Flow Chart
Trouble Diagnosis Procedure
INTERVIEW WITH CUSTOMER
Interview with the customer is important to detect the root cause of CAN
communication system errors and to
understand vehicle condition and symptoms for proper trouble diagnosis. ...