Nissan Altima (L32) 2007-2012 Service Manual: Service data and specifications (SDS)
Idle Speed
*: Under the following conditions
• A/C switch: OFF
• Electric load: OFF (Lights, heater fan & rear window defogger)
• Steering wheel: Kept in straight-ahead position
Ignition Timing
*: Under the following conditions
• A/C switch: OFF
• Electric load: OFF (Lights, heater fan & rear window defogger)
• Steering wheel: Kept in straight-ahead position
Calculated Load Value
Mass Air Flow Sensor
*: Engine is warmed up to normal operating temperature and running under no load.
On-vehicle repair
EVAP CANISTER Exploded View Removal and Installation REMOVAL 1. Lift up the vehicle. 2. Remove EVAP canister fixing bolt. 3. Remove EVAP canister. NOTE: The EVAP canister vent contro ...Engine control system QR25DE except for california
Basic inspection DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the c ...Other materials:
Steering gear and linkage
Exploded View
1. Cotter pin
2. Steering gear assembly
Removal and Installation
REMOVAL
1. Remove the front tires.
2. Remove undercover using power tool.
3. Remove lower side bolt of lower joint.
4. Remove cotter pin (1), and then loosen the nut.
5. Remove steering outer socket ...
P0143 HO2S3
Description
The heated oxygen sensor 3, after HC adsorption catalyst (Under
floor), monitors the oxygen level in the exhaust gas on each bank.
This sensor is made of ceramic zirconia. The zirconia generates voltage
from approximately 1V in richer conditions to 0V in leaner conditions.
Unde ...
Diagnosis and repair workflow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1. GET INFORMATION FOR SYMPTOM
Get the detailed information from the customer about the symptom (the
condition and the environment when
the incident/malfunction occurred).
>> GO TO 2
2. CHECK DTC
1. Check DTC.
2. Perform the following p ...