Nissan Altima 2007-2012 Service Manual: Side oil seal
Removal and Installation
REMOVAL
1. Remove the drive shaft. Refer to FAX-11, "Removal and Installation (Left Side)", FAX-12, "Removal and Installation (Right Side)".
2. Remove oil seal using suitable tool.
CAUTION: Do not damage the transaxle case surface when removing oil seal.
INSTALLATION
1. Drive the oil seal straight into the transaxle case and clutch housing to the specified dimension "A" using Tools.
CAUTION: Do not reuse oil seal.
2. Install the drive shaft. Refer to FAX-11, "Removal and Installation (Left Side)", FAX-12, "Removal and Installation (Right Side)".
3. Check the transaxle fluid level. Refer to TM-17, "Inspection".
Back-up lamp switch
Removal and Installation
For removal and installation of back-up lamp switch, refer to TM-28,
"Exploded View".
Inspection
• Check continuity.
...
Other materials:
Automatic operation
Cooling and/or dehumidified heating
(AUTO)
This mode may be used all year round as the
system automatically works to keep a constant
temperature. Air flow distribution and fan speed
are also controlled automatically.
1. Press the AUTO button on. The indicator on
the button will illuminate.
...
Combination switch output circuit
Diagnosis Procedure
1. CHECK OUTPUT 1 - 5 SYSTEM CIRCUIT FOR OPEN
1. Turn the ignition switch OFF.
2. Disconnect the BCM and combination switch.
3. Check continuity between BCM harness connector and combination
switch harness connector.
Does continuity exist?
YES >> GO TO 2
NO ...
Water outlet and water piping
Removal and Installation
1. Water outlet
2. Gasket
3. O-ring
4. Heater pipe
5. Water connector
6. Water bypass pipe
7. Engine coolant temperature sensor
8. Washer
A. To electric throttle control actuator
B. To heater
C. To radiator
D. From heater or transmission oil cooler
(if equippe ...