Nissan Altima (L33) 2013-2018 Owners Manual: Speedometer and odometer
Speedometer
The speedometer indicates vehicle speed.
Odometer/Twin trip odometer
The odometer 1 and the twin trip odometer 2 are displayed below the Vehicle Information Display when the ignition switch is placed in the ON position.
The odometer records the total distance the vehicle has been driven.
The twin trip odometer records the distance of individual trips.
Changing the display:
Pushing the TRIP RESET 3 switch on the left of
the instrument panel to change the display as
follows:
Trip 
→ Trip
→ Trip
Resetting the trip odometer:
Pushing the TRIP RESET switch 3 for more than 1 second resets the currently displayed trip odometer to zero.
Average fuel economy and distance to empty information is also available. See “Vehicle Information Display” in this section.
Meters and gauges
1. Tachometer
2. Warning/indicator lights
3. Vehicle Information Display
4. Speedometer
5. Fuel gauge
6. Odometer/Twin trip odometer
7. Engine coolant temperature gauge ...
Tachometer
The tachometer indicates engine speed in revolutions
per minute (rpm). Do not rev engine into
the red zone 1 .
CAUTION
When engine speed approaches the red
zone, shift to a higher gear or reduc ...
Other materials:
B2014 chain of strg-immu
Description
BCM performs the ID verification with the steering lock unit to release the
steering. BCM starts the communication
with the steering lock unit when Intelligent Key is carried into the passenger
compartment and the pushbutton
ignition switch is pressed.
DTC Logic
DTC DETECTION L ...
On board refueling vapor recovery (ORVR)
Description
From the beginning of refueling, the air and vapor inside the fuel tank go
via the refueling EVAP vapor cut
valve and EVAP/ORVR line to the EVAP canister. The vapor is absorbed by the EVAP
canister and the air is
released to the atmosphere.
When the refueling has reached the ...
P1574 ASCD vehicle speed sensor
Description
The ECM receives two vehicle speed signals via CAN communication line. One is
sent from combination
meter, and the other is from TCM (Transmission control module). The ECM uses
these signals for ASCD control.
Refer to EC-67, "System Description" for ASCD functions.
D ...
