Nissan Altima (L32) 2007-2012 Service Manual: Steering column
Disassembly and Assembly
CAUTION: • Any time the ignition switch has been disconnected, removed or installed, the keys must be re-registered in the BCM. Refer to Consult-III operations IVIS/NVIS.
The steering column assembly is not serviceable and must be replaced as an assembly.
Steering gear and linkage
Exploded View
1. Outer socket
2. Boot clamp
3. Boot
4. Inner socket
5. Boot clamp
6. SSPS valve (part of gear assembly)
7. Gear assembly
Disassembly
1. Remove outer socket locknut and o ...
Other materials:
Front timing chain case
Removal and Installation
1. Gasket
2. IVT control valve cover RH
3. IVT valve RH
4. IVT valve LH
5. Water pump cover
6. IVT control valve cover LH
7. Crankshaft pulley
8. Front oil seal
9. Front timing chain case
A. Follow installation procedure
NOTE:
• This section describes procedu ...
B2108 steering lock relay
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2108 is displayed with DTC U1000, first perf ...
P1225 TP Sensor
Description
Electric throttle control actuator consists of throttle control motor,
throttle position sensor, etc. The throttle position sensor responds to
the throttle valve movement.
The throttle position sensor has two sensors. These sensors are a
kind of potentiometers which transform the ...
