Nissan Altima (L32) 2007-2012 Service Manual ≻ Steering system ≻ On-vehicle repair ≻ Steering wheel

Nissan Altima (L32) 2007-2012 Service Manual: Steering wheel

Removal and Installation

REMOVAL

NOTE: When reconnecting spiral cable, fix cable with a tape so that fixing case and rotating part keep aligned. This will omit neutral position alignment procedure during spiral cable installation.

1. Set vehicle to the straight-ahead position.

2. Remove driver air bag module. Refer to SR-5, "Removal and Installation".

3. Remove steering wheel lock nut after steering is locked.

4. Remove steering wheel using Tool (A).

Tool number A: ST27180001 (J-25726-A)

INSTALLATION

Installation is in the reverse order of removal.

NOTE: Align the spiral cable. Refer to SR-8, "Removal and Installation".

Steering gear and linkage

Exploded View 1. Cotter pin 2. Steering gear assembly Removal and Installation REMOVAL 1. Remove the front tires. 2. Remove undercover using power tool. 3. Remove lower side bolt of lo ...

Other materials:

Brake fluid
For additional information on brake fluid specification, see "Recommended fluids/ lubricants and capacities". WARNING Use only new fluid from a sealed container. Old, inferior or contaminated fluid may damage the brake system. The use of improper fluids can damage the brake system and affect ...

BSW system limitations
WARNING Listed below are the system limitations for the BSW system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The BSW system cannot detect all vehicles under all conditions. The radar sensors may not be able to detect and ...

Installing the spare tire
WARNING For AWD vehicles - the TEMPORARY USE ONLY spare tire must be installed to the rear wheels only. If a front tire is punctured, install the original rear tire onto the front wheel, then install the TEMPORARY USE ONLY spare tire on the rear. Failure to do so could cause overheating to the AWD ...