Nissan Altima 2007-2012 Service Manual: Stop lamp

Bulb Replacement

Removal

1. Remove rear combination lamp. Refer to EXL-257, "Removal and Installation".

2. Turn bulb socket counterclockwise to unlock and remove from combination lamp assembly.

3. Turn bulb counterclockwise to remove from bulb socket.

Installation

Installation is in the reverse order of removal.

Removal and Installation

HIGH MOUNTED STOP LAMP (with rear spoiler)

The high-mounted stop lamp uses an LED circuit board instead of a bulb. The LED circuit board is not serviceable and the high-mounted stop lamp must be replaced as an assembly. Refer to EXT-47, "Removal and Installation".

HIGH-MOUNTED STOP LAMP (with parcel shelf)

Removal

1. Slide the high-mounted stop lamp assembly rearward on the parcel shelf to give clearance to the front tabs.

2. Lift the front of the lamp assembly up and slide it forward to give clearance to the rear tabs.

3. Disconnect the high-mounted stop lamp connector and remove.

Installation

Installation is in the reverse order of removal.

REAR COMBINATION LAMP

Removal

1. Remove the trunk side finisher. Refer to INT-46, "Removal and Installation".

2. From inside the trunk, remove the rear combination lamp assembly nuts.

3. Disconnect the connectors and remove the rear combination lamp assembly.

Installation

Installation is in the reverse order of removal.

    Front fog lamp
    Bulb Replacement REMOVAL The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. CAUTION: • Do not touch the glass of bulb directly by hand. Keep grease and other oily ...

    Back-up lamp
    Bulb Replacement Removal 1. Remove the rear combination lamp. Refer to EXL-260, "Removal and Installation". 2. Turn back-up lamp bulb socket counterclockwise to unlock and remove. ...

    Other materials:

    P1723 CVT speed sensor function
    Description The vehicle speed sensor CVT [output speed sensor (secondary speed sensor)] detects the revolution of parking gear and generates a pulse signal. The pulse signal is sent to the TCM, which converts it into vehicle speed. The input speed sensor (primary speed sensor) detects the ...

    Transmission control module
    Exploded View 1. TCM 2. Bracket 3. Battery Removal and Installation REMOVAL 1. Disconnect the battery negative terminal. 2. Remove the fresh air intake tube (upper). 3. Disconnect the TCM harness connector. 4. Remove the TCM (1) from the bracket (2). • Battery (3) INSTALL ...

    P0441 evap control system
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0441 is displayed with other DTC such as P2122, P2123, P2127, P2128 or P2138, first perform trouble diagnosis for other DTC. In this evaporative emission (EVAP) control system, purge flow occurs during non-closed throttle conditions. Purge vo ...