Nissan Altima (L32) 2007-2012 Service Manual: STRG branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair the terminal and connector.
2.CHECK HARNESS FOR OPEN CIRCUIT
1. Disconnect the connector of steering angle sensor.
2. Check the resistance between the steering angle sensor harness connector terminals.
Is the measurement value within the specification? YES >> GO TO 3.
NO >> Repair the steering angle sensor branch line.
3.CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the steering angle sensor. Refer to BRC-207, "Wiring Diagram - Coupe" or BRC-215, "Wiring Diagram - Sedan".
Is it normal? YES (Present error)>>Replace the steering angle sensor. Refer to BRC-242, "Removal and Installation" .
YES (Past error)>>Error was detected in the steering angle sensor branch line.
NO >> Repair the power supply and the ground circuit.
M&A branch line circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...ABS branch line circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...Other materials:
Oil cooler
Removal and Installation
1. Oil pressure switch
2. Oil cooler
3. Gasket
4. Water hose (outlet)
5. Water hose (inlet)
A. To water control valve housing
B. To heater pipe assembly
C. Hose clamp
D. Clip
WARNING:
Be careful not to get burned, engine coolant and engine oil may be hot.
CAUTI ...
P0461 fuel level sensor
Description
The fuel level sensor is mounted in the fuel level sensor unit.
The sensor detects a fuel level in the fuel tank and transmits a signal to the
combination meter. The combination
meter sends the fuel level sensor signal to the ECM through CAN communication
line.
It consists o ...
S Terminal circuit
Description
The output voltage of the generator is controlled by the IC regulator at
terminal “3” (S) detecting the input voltage.
Terminal “3” circuit detects the battery voltage to adjust the generator output
voltage with the IC regulator.
Diagnosis Procedure
1.CHECK VOLTAGE REG ...