Nissan Altima 2007-2012 Service Manual: STRG branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair the terminal and connector.
2.CHECK HARNESS FOR OPEN CIRCUIT
1. Disconnect the connector of steering angle sensor.
2. Check the resistance between the steering angle sensor harness connector terminals.
Is the measurement value within the specification? YES >> GO TO 3.
NO >> Repair the steering angle sensor branch line.
3.CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the steering angle sensor. Refer to BRC-207, "Wiring Diagram - Coupe" or BRC-215, "Wiring Diagram - Sedan".
Is it normal? YES (Present error)>>Replace the steering angle sensor. Refer to BRC-242, "Removal and Installation" .
YES (Past error)>>Error was detected in the steering angle sensor branch line.
NO >> Repair the power supply and the ground circuit.
M&A branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors ...
ABS branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors ...
Other materials:
Front door speaker
Removal and Installation
REMOVAL
1. Remove the front door finisher. Refer to INT-12, "Removal and
Installation" (coupe) and INT-34, "Removal
and Installation" (sedan).
2. Remove the front door speaker screws (A), then disconnect the
front door speaker connector and remo ...
Turn signal lamp circuit
Description
The BCM monitors inputs from the combination switch to determine when to
activate the turn signals. The
BCM outputs voltage direction to the left and right turn signals during turn
signal operation or both during hazard
warning operation. The BCM sends a turn signal indicator req ...
Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING
CONTROL UNIT
Service After Replacing TCM
and Transaxle Assembly
Perform the applicable service in the following sheet when replacing TCM
or transaxle assembly.
CAUTION:
• Do not start the engine until the service is completed.
• “TCM-POWER S ...