Nissan Altima 2007-2012 Service Manual: Subwoofer (sedan)
Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the subwoofers using the audio signal circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect BOSE speaker amp. connector B122 and suspect rear subwoofer connector.
2. Check continuity between BOSE speaker amp. harness connector B122 (A) and suspect rear subwoofer harness connector (B).
3. Check continuity between BOSE speaker amp. harness connector B122 (A) and ground.
Are the continuity test results as specified? YES >> GO TO 2
NO >> • Check connector housings for disconnected or loose terminals.
• Repair harness or connector.
2.REAR SUBWOOFER SIGNAL CHECK
1. Connect BOSE speaker amp. connector B122 and suspect rear subwoofer connector.
2. Turn ignition switch to ACC.
3. Push “POWER” switch.
4. Check the signal between BOSE speaker amp. harness connector B122 terminals with CONSULT-III or oscilloscope.
Is the audio signal voltage as specified? YES >> Replace suspect rear subwoofer. Refer to AV-445, "Removal and Installation".
NO >> GO TO 3
3.HARNESS CHECK
1. Disconnect AV control unit connector M47 and BOSE speaker amp. connector B121.
2. Check continuity between AV control unit harness connector M47 (A) and BOSE speaker amp. harness connector B121 (B).
3. Check continuity between AV control unit harness connector M47 (A) and ground.
Are continuity test results as specified? YES >> GO TO 4
NO >> • Check connector housings for disconnected or loose terminals.
• Repair harness or connector.
4.REAR SUBWOOFER SIGNAL CHECK
1. Connect AV control unit connector M47 and BOSE speaker amp. connector B121.
2. Turn ignition switch to ACC.
3. Push “POWER” switch.
4. Check the signal between AV control unit harness connector M47 terminals with CONSULT-III or oscilloscope.
Are the audio signal voltage readings as specified? YES >> Replace BOSE speaker amp. Refer to AV-438, "Removal and Installation - Sedan".
NO >> Replace AV control unit. Refer to AV-437, "Removal and Installation".
Subwoofer (coupe)
Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the subwoofers using the audio signal circuits. D ...AMP On signal circuit
Description When the audio system is turned on, a voltage signal is supplied from the AV control unit to the BOSE speaker amp. When this signal is received, the BOSE speaker amp. will turn on. Di ...Other materials:
Engine control system symptoms
Symptom Table
SYSTEM — BASIC ENGINE CONTROL SYSTEM
1 - 6: The numbers refer to the order of inspection.
(continued on next table)
SYSTEM — ENGINE MECHANICAL & OTHER
1 - 6: The numbers refer to the order of inspection. ...
P0442 evap control system
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0442 is displayed with DTC P0456, first perform the trouble diagnosis
for DTC P0456. Refer to
EC-336, "DTC Logic".
This diagnosis detects leaks in the EVAP purge line using engine intake
manifold vacuum.
If pressure does not increase ...
Door key cylinder switch
Description
Main power window and door lock/unlock switch detects condition of the door
key cylinder and transmits to
BCM as the LOCK or UNLOCK signals.
Component Function Check
1. CHECK DOOR KEY CYLINDER SWITCH INPUT SIGNAL
Check (“KEY CYL LK-SW”, “KEY CYL UN-SW”) in “DATA MONITOR ...