Nissan Altima (L32) 2007-2012 Service Manual: Sunload sensor
Removal and Installation
REMOVAL
1. Remove the front RH speaker grille (1). Refer to AV-73, "Removal and Installation".
2. Disconnect the connector.
3. Release the sunload sensor tabs (A) to remove it from the front RH speaker grille (1).
INSTALLATION
Installation is in the reverse order of removal.
In-vehicle sensor
Removal and Installation REMOVAL 1. Remove the instrument lower cover LH. Refer to IP-12, "Removal and Installation". 2. Remove the in-vehicle sensor screw and remove the in-vehicle ...Intake sensor
Removal and Installation REMOVAL 1. Remove the evaporator. Refer to VTL-20, "Removal and Installation". 2. Release the intake sensor clip and then remove the intake sensor. CAUTION: ...Other materials:
B210E starter relay
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210E is displa ...
Satellite radio antenna
Removal and Installation
REMOVAL
1. Lower the headliner at the rear. Refer to INT-20, "Removal and
Installation" (coupe) and INT-42,
"Removal and Installation" (sedan).
2. Remove the satellite radio antenna nut (A), then disconnect the
satellite radio antenna connector ( ...
P0117, P0118 ECT sensor
Description
The engine coolant temperature sensor is used to detect the engine
coolant temperature. The sensor modifies a voltage signal from the
ECM. The modified signal returns to the ECM as the engine coolant
temperature input. The sensor uses a thermistor which is sensitive to
the change in ...