Nissan Altima 2007-2012 Service Manual: Suspension ARM

Removal and Installation

Removal

1. Remove the rear suspension assembly. Refer to RSU-12, "Removal and Installation".

2. Remove the connecting rod bracket from the suspension arm using power tools.

3. Remove the two suspension arm bolts and nuts from the suspension member side of the suspension arm using power tools.

4. Remove the ball joint cotter pin and lock nut using power tools.

• Discard the cotter pin, use a new cotter pin for installation.

5. Remove the suspension arm from the knuckle using Tool.

Tool number : HT72520000 (J-25730-A)

CAUTION: • Do not damage ball joint when removing.

• While using Tool, temporarily tighten the nut so as not to damage screw threads.

Installation

Installation is in the reverse order of removal.

• Discard the cotter pin, use a new cotter pin for installation.

• Check the rear wheel alignment and adjust if necessary. Refer to RSU-18, "Rear Wheel Alignment (Unladen*)".

    Rear stabilizer
    Removal and Installation Removal 1. Disconnect the stabilizer bar from connecting rod, using power tools. 2. Remove the stabilizer bar clamps and bushings using power tools. 3. Remove the sta ...

    Service data and specifications (SDS)
    General Specification (Rear) Rear Wheel Alignment (Unladen*) *: Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions. *: Fuel, engine ...

    Other materials:

    Headlamp (halogen type)
    System Diagram System Description Control of the headlamp system operation is dependent upon the position of the lighting switch (combination switch). When the lighting switch is placed in the 2nd position, the BCM (body control module) receives input requesting the headlamps and park lam ...

    P0101 maf sensor
    Description The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is reduced as ...

    Precaution
    Supplemental Restraint System (SRS) AIR BA G and SEAT BELT PRE-TENSIONER The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain ...