Nissan Altima 2007-2012 Service Manual: TEL Antenna
Removal and Installation - Coupe
REMOVAL
1. Remove the trunk front finisher, trunk floor carpet and spare tire cover. Refer to INT-22, "Exploded View".
2. Remove the LH trunk floor spacer.
3. Remove the rear pillar LH. Refer to INT-20, "Exploded View".
4. Remove the rear parcel shelf. Refer to INT-17, "Removal and Installation".
5. Remove the Bluetooth antenna screw (A), then detach the Bluetooth antenna harness clips, disconnect the Bluetooth antenna connector and remove the Bluetooth antenna (1).
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation - Sedan
REMOVAL
1. Remove the rear parcel shelf. Refer to INT-38, "Removal and Installation".
2. Remove the Bluetooth antenna screw (A), fold down the rear seat, disconnect the Bluetooth antenna connector and remove the Bluetooth antenna (1).
INSTALLATION
Installation is in the reverse order of removal.
Microphone
Removal and Installation REMOVAL 1. Remove the room/map lamp assembly. Refer to INL-121, "Removal and Installation". 2. Detach the microphone connector (A). 3. Remove the map lamp ...Bluetooth control unit
Removal and Installation - Coupe REMOVAL 1. Disconnect the battery negative terminal. 2. Remove the trunk floor carpet and spare tire cover. Refer to INT-22, "Exploded View". 3. R ...Other materials:
Push-button ignition switch positions
LOCK (Normal parking position):
The ignition switch can only be locked in this
position.
The ignition switch will be unlocked when it is
pushed to the ACC position while carrying the
Intelligent Key.
The ignition switch will lock when any door is
opened or closed with the ignition switche ...
Function information
Component Part Location
ENGINE COMPARTMENT
1. A/C compressor F3
2. Refrigerant pressure sensor E219
3. A/C relay (internal to IPDM E/R)
1. A/C compressor F3
2. Refrigerant pressure sensor E219
3. A/C relay (internal to IPDM E/R)
PASSENGER COMPARTMENT
1. Intake door motor M126
2. Fro ...
P0462, P0463 Fuel level sensor
Description
The fuel level sensor is mounted in the fuel level sensor unit.
The sensor detects a fuel level in the fuel tank and transmits a signal to the
combination meter. The combination
meter sends the fuel level sensor signal to the ECM via the CAN communication
line.
It consists of ...