Nissan Altima 2007-2012 Service Manual: Throttle valve closed position learning
Description
Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconnected.
Special Repair Requirement
1.START
1. Make sure that accelerator pedal is fully released.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
Make sure that throttle valve moves during above 10 seconds by confirming the operating sound.
>> END
Accelerator pedal released position
learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor outp ...
Idle air volume learning
Description
Idle Air Volume Learning is a function of ECM to learn the idle air volume
that keeps each engine idle speed
within the specific range. It must be performed under any of the following ...
Other materials:
Front fog lamp
System Diagram
System Description
• BCM (Body Control Module) controls front fog lamp operation.
• IPDM E/R (Intelligent Power Distribution Module Engine Room) operates front
fog lamp according to CAN
communication signals from BCM.
• Combination meter operates front fog lamp indi ...
Water outlet and water piping
Removal and Installation
1. Water outlet
2. Gasket
3. O-ring
4. Heater pipe
5. Water connector
6. Water bypass pipe
7. Engine coolant temperature sensor
8. Washer
A. To electric throttle control actuator
B. To heater
C. To radiator
D. From heater or transmission oil cooler
(if equippe ...
B210c starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay
operation when in N or P position and
the steering is locked or unlocked. It is installed in parallel with the starter
relay.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210C is displayed with DTC U100 ...