Nissan Altima (L32) 2007-2012 Service Manual ≻ Road wheels & tires ≻ On-vehicle repair ≻ Tire pressure receiver

Nissan Altima (L32) 2007-2012 Service Manual: Tire pressure receiver

Removal and Installation

REMOVAL

1. Remove instrument lower cover (LH). Refer to IP-11, "Exploded View".

2. Locate tire pressure receiver (1) to the right of the steering column (2) and disconnect tire pressure receiver electrical connector.

3. Remove tire pressure receiver (1) from bracket using a suitable tool to release the bracket.

INSTALLATION

Installation is in the reverse order of removal.

Road wheel tire assembly

Adjustment WHEEL BALANCE 1. Remove inner and outer balance weights from the wheel. CAUTION: • Be careful not to scratch the wheel during removal procedures. 2. Using releasing agent, remove d ...

Other materials:

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused by objects such ...

LDW system operation
For vehicles with the 7 inch (18 cm) display The LDW system provides a lane departure warning function when the vehicle is driven at speeds of approximately 37 mph (60 km/h) and above and the lane markings are clear. When the vehicle approaches either the left or the right side of the traveling lan ...

Vehicle information display warnings and indicators
The following messages may appear in your vehicle information display. Engine start operation for Intelligent Key system (if I-Key battery level is low) This indicator appears when the battery of the Intelligent Key is low and when the Intelligent Key system and the vehicle are not communicating no ...