Nissan Altima 2007-2012 Service Manual: Transverse link

Removal and Installation

REMOVAL

1. Remove wheel and tire. Refer to WT-66, "Adjustment".

2. Remove steering knuckle from transverse link. Refer to FSU-12, "Exploded View".

3. Remove mounting nuts and washers on lower portion of stabilizer connecting rod.

4. Slightly loosen transverse link mounting bolts.

5. Remove transverse link bolts and nuts, and remove transverse link from suspension member.

INSPECTION AFTER REMOVAL

Visual Inspection

Check transverse link and bushing for deformation, cracks, and other damage. Replace the entire transverse link assembly if cracks, deformation or any other damage is found.

Ball Joint Inspection

CAUTION: Before measurement, move the ball joint at least ten times by hand to check for smooth movement.

Swing Torque Inspection

• Hook spring scale at cotter pin mounting hole. Confirm spring scale measurement value is within specifications when ball stud begins moving.

• If the value is outside the standard, replace transverse link.

Rotating Torque Inspection

• Attach nut to ball stud. Check that rotating torque is within specifications using Tool.

• If the value is outside the standard, replace transverse link.

Axial Endplay Inspect

• Move tip of ball joint in axial direction to check for looseness.

Axial endplay : 0.1 mm (0.004 in) or less

• If any looseness is noted, replace transverse link.

INSTALLATION

Installation is in the reverse order of removal.

• Refer to FSU-12, "Exploded View" for tightening torque.

• Tighten transverse link bolts with vehicle unladen and all four tires on flat, level ground.

• After installation, check wheel alignment. Refer to FSU-7, "Inspection and Adjustment".

    Front coil spring and strut
    Removal and Installation REMOVAL 1. Remove wheel and tire. Refer to WT-66, "Adjustment". 2. Remove brake caliper and reposition aside using wire. Refer to BR-30, "BRAKE CALIPER A ...

    Front stabilizer
    Removal and Installation REMOVAL 1. Remove steering gear. Refer to ST-17, "Removal and Installation". 2. Remove mounting nuts on upper portion of stabilizer connecting rod. 3. Remov ...

    Other materials:

    To protect your vehicle from corrosion
    ● Wash and wax your vehicle often to keep the vehicle clean. ● Always check for minor damage to the paint and repair it as soon as possible. ● Keep drain holes at the bottom of the doors open to avoid water accumulation. ● Check the underbody for accumulation of sand, ...

    U1010 control unit (CAN)
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability. Many electronic control units are equipped onto a vehicle, an ...

    Intake valve timing control
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *: This signal is sent to the ECM through CAN communication line SYSTEM DESCRIPTION This mechanism hydraulically controls cam phases continuously with the fixed operating angle of the intake valve. The ECM receives signals s ...