Nissan Altima 2007-2012 Service Manual: Trunk room trim & trunk lid finisher
Exploded View
TRUNK ROOM TRIM
1. Upper trunk finisher
2. Trunk lid finisher
3. Trunk side finisher (RH)
4. Trunk floor carpet
5. Trunk side finisher (LH)
6. Trunk spacer (LH)
7. Spare tire cover
8. Trunk net rear
9. Trunk spacer (RH)
10. Trunk rear finisher
11. Trunk net side
Removal and Installation
REMOVAL
TRUNK ROOM TRIM
1. Release the clips, then remove trunk floor carpet.
2. Remove trunk net rear and trunk net side (if equipped).
3. Release the clips, then remove trunk rear finisher.
4. Release the clips, then remove upper trunk finisher.
5. Release the clips, then remove trunk side finisher (RH/LH).
6. Remove spare tire cover and trunk spacers (RH/LH).
7. Release the clips and remove trunk lid finisher.
INSTALLATION
Installation is in the reverse order of removal.
Headlining
Exploded View
1. Headlining assembly (without
sunroof)
2. Assist grip
3. Headlining assembly (with sunroof)
4. Front room/Map lamp assembly
bracket
5. Front room/Map lamp assembly
6. Sunviso ...
Interior Sedan
...
Other materials:
P0826 manual mode switch
Description
Manual mode switch is installed in shift control device. The manual mode
switch sends shift up and shift down
switch signals to TCM with CAN communication.
TCM sends the switch signals to combination meter via CAN communication line.
Then manual mode switch
position is indicat ...
Additional service when replacing control unit
Description
When replacing ECM, this procedure must be performed.
Special Repair Requirement
1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION
KEY IDS
Refer to SEC-15, "ECM RE-COMMUNICATING FUNCTION : Special Repair Requirement"
(Coupe) or SEC-
214, &qu ...
Ignition signal
Description
The ignition signal from the ECM is sent to and amplified by the power
transistor. The power transistor turns
ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the
proper high voltage in the coil
secondary circuit.
Component Function Check
1.INSPECTION ...