Nissan Altima 2007-2012 Service Manual: Tweeter (sedan)

Description

The audio unit sends audio signals to the tweeters using the door speaker circuits.

Diagnosis Procedure

1.HARNESS CHECK

1. Disconnect audio unit connector M43 (A) and suspect tweeter connector (B).

2. Check continuity between audio unit harness connector M43 (A) and suspect tweeter harness connector (B).

3. Check continuity between audio unit harness connector M43 (A) and ground.

Are the continuity results as specified? YES >> GO TO 2

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

2.TWEETER SIGNAL CHECK

1. Connect audio unit connector and tweeter connector.

2. Turn ignition switch to ACC.

3. Push “POWER” switch.

4. Check the signal between audio unit harness connector terminals with CONSULT-III or oscilloscope.

Is the audio signal voltage as specified? YES >> Replace tweeter. Refer to AV-73, "Removal and Installation".

NO >> Replace audio unit. Refer to AV-72, "Removal and Installation".

    Front tweeter (coupe)
    Description The audio unit sends audio signals to the front tweeters using the door speaker circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect audio unit connector M43 (A) and suspect ...

    Rear speaker
    Description The audio unit sends audio signals to the rear speakers using the rear speaker circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect audio unit connector M43 (A) and suspect s ...

    Other materials:

    Front wheel hub and knuckle
    Removal and Installation 1. Cotter pin 2. Disc rotor 3. Wheel hub and bearing assembly 4. Splash guard 5. Steering knuckle REMOVAL 1. Remove wheel and tire from vehicle. Refer to WT-66, "Adjustment". 2. Remove brake caliper using power tool, leaving brake caliper hydraulic li ...

    Key cylinder switch
    Description For vehicles equipped with LH and RH anti-pinch system, the main power window and door lock/unlock switch detects condition of the door key cylinder switch and transmits to BCM as the LOCK or UNLOCK signal. For vehicles equipped with LH anti-pinch system only, the door lock ass ...

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the malfunctioning parts. 2. C ...