Nissan Altima 2007-2012 Service Manual: U0415 vehicle speed sig
Description
U0415 is displayed if any unusual condition is present in the reception status of the vehicle speed signal from the ABS actuator and electric unit (control unit).
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1. DTC CONFIRMATION
1. Erase the DTC.
2. Turn ignition switch OFF.
3. Perform the "SELF-DIAG RESULTS" of CONSULT-III, after the ignition switch has been turned ON for 2 seconds or more.
Is any DTC detected? YES >> Refer to BCS-91, "DTC Index".
NO >> Inspection End.
Diagnosis Procedure
1. ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAG RESULTS
Perform "SELF-DIAG RESULTS" of ABS actuator and electric unit (control unit) with CONSULT-III. Refer to BRC-12, "CONSULT-III Function (ABS)".
Is any DTC detected? YES >> Repair or replace the malfunctioning part.
NO >> Replace BCM. Refer to BCS-96, "Removal and Installation".
U1010 control unit (can)
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1. REPLACE BCM
When DTC U1010 is detected, replace BCM.
>> Replace BCM. Refer to BCS-96, "Removal and Installation". ...
B2562 low voltage
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1. DTC CONFIRMATION
1. Erase DTC.
2. Turn ignition switch OFF.
3. Perform the "SELF-DIAG RESULTS" of CONSULT-III, after t ...
Other materials:
Heater operation
Heating
This mode is used to direct heated air to the foot
outlets. Some air also flows from the defrost
outlets and the side vent outlets.
1. Press the button to the OFF
position
for normal heating.
2. Press the air flow control
button.
3. Turn the fan control dial to the desired ...
U120D DVD-ROM drive mecha
Description
Refer to AV-240, "System Description".
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK DVD-ROM
Check DVD-ROM for dirt, scratches and warpage.
Is the DVD-ROM clean and undamaged?
YES >> Replace AV control unit. Refer to AV-437, "Removal and Ins ...
Connecting Procedure
NOTE:
The connecting procedure must be performed
when the vehicle is stationary. If the
vehicle starts moving during the procedure,
the procedure will be cancelled.
1. Press the [ ] button on the
control
panel.
2. Select the “Settings” key.
3. Select the “Phone & Bluetooth” ...