Nissan Altima 2007-2012 Service Manual: U1000 CAn comm circuit

Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability.

Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF.

Then wait at least 10 seconds before performing the next test.

1.CHECK DTC DETECTION

1. Turn ignition switch ON.

2. Start engine and wait for at least 6 seconds.

3. Perform “SELF-DIAG RESULTS” mode for “TRANSMISSION”.

Follow the procedure “With CONSULT-III”.

Is “U1000 CAN COMM CIRCUIT” detected? YES >> Go to TM-123, "Diagnosis Procedure".

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

Diagnosis Procedure

1.CHECK CAN COMMUNICATION CIRCUIT

1. Turn ignition switch ON and start engine.

2. Perform “SELF-DIAG RESULTS” mode for “TRANSMISSION”.

Is “U1000 CAN COMM CIRCUIT” indicated? YES >> Go to LAN section. Refer to LAN-25, "CAN System Specification Chart".

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    P0615 start signal
    Description • TCM controls starter relay in IPDM E/R. • TCM switches starter relay ON at “P” or “N” position and allows to crank engine. • Then it prohibits cranking other than ...

    Other materials:

    Key slot
    Diagnosis Procedure 1.CHECK KEY SLOT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect key slot connector. 3. Check voltage between slot connector and ground. Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace key slot power supply circui ...

    FM/AM radio with compact disc (CD) player (Type A) (if so equipped)
    1. CD eject button 2. CD button 3. Display screen 4. CD insert slot 5. SEEK button 6. SCAN button 7. TRACK button 8. BACK button 9. iPod MENU button 10.TUNE/FOLDER knob, ENTER/SETTING button 11.Station select (1 - 6) buttons 12.RDM button 13.RPT button 14.VOL (volume) knob / butto ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...