Nissan Altima 2007-2012 Service Manual: U1000 can comm circuit

DescriptionCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

CAN Communication Signal Chart, refer to LAN-25, "CAN Communication Signal Chart".

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure

1.PERFORM SELF DIAGNOSTIC

1. Turn ignition switch ON and wait for 2 seconds or more.

2. Check “Self Diagnostic Result”.

Is “CAN COMM CIRCUIT” displayed? YES >> Refer to LAN-8, "CAN Communication Control Circuit".

NO >> Refer to GI-42, "Intermittent Incident".

    U1010 control unit (can)
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1. REPLACE BCM When DTC U1010 is detected, replace BCM. >> Replace BCM. Refer to BCS-96, "Removal and Installation". ...

    Other materials:

    Driver side
    Description Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch. Component Function Check 1. CHECK FRONT POWER WINDOW MOTOR LH CIRCUIT Does front power window motor LH operate with the main power window and door lock/unlock switch? Is the ins ...

    B2192, P1611 ID discord, IMMU-ECM
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON. DTC Logic DTC DETECTION LOGIC ...

    P1722 estm vehicle speed signal
    Description The vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) to TCM by CAN communication line. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” ha ...