Nissan Altima 2007-2012 Service Manual: U1000 can comm circuit

Description

Refer to LAN-7, "System Description".

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure

1. PERFORM SELF DIAGNOSTIC

1. Turn ignition switch ON and wait for 2 second or more.

2. Check “SELF- DIAG RESULTS”.

Is “CAN COMM CIRCUIT” displayed? YES >> Refer to LAN-8, "CAN Communication Control Circuit".

NO >> Refer to GI-42, "Intermittent Incident".

    U1010 control unit (can)
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1. REPLACE BCM When DTC U1010 is detected, replace BCM. >> Replace BCM. Refer to BCS-96, "Removal and Installation". ...

    Other materials:

    Diagnosis system (BCM)
    COMMON ITEM Diagnosis Description BCM CONSULT-III FUNCTION CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the following for all sub s ...

    IPDM-E branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - TCM - Harnes ...

    Subwoofer
    Components 1. Subwoofer speaker 2. Spacer A. Screws Removal and Installation REMOVAL 1. Remove the rear parcel shelf finisher. Refer to INT-17, "Removal and Installation" (coupe) and INT-38, "Removal and Installation" (sedan). 2. Remove the trunk front finisher. Re ...