Nissan Altima 2007-2012 Service Manual: U1000 can comm circuit

Description

Refer to LAN-7, "System Description".

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

Diagnosis Procedure

1. PERFORM SELF DIAGNOSTIC

1. Turn ignition switch ON and wait for 2 second or more.

2. Check “Self Diagnostic Result” of IPDM E/R.

Is “CAN COMM CIRCUIT” displayed? YES >> Refer to PCS-20, "DTC Logic".

NO >> Refer to GI-42, "Intermittent Incident".

    B2098 ignition relay on stuck
    Description • IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. • Turn the ignition relay OFF by pressing the push-button ig ...

    Other materials:

    B2618 BCM
    Description BCM controls the various electrical components and simultaneously supplies power according to the power supply position. BCM checks the power supply position internally. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2618 is displayed with DTC U1000, first perform the trouble ...

    Front door speaker
    Removal and Installation REMOVAL 1. Remove the front door finisher. Refer to INT-12, "Removal and Installation" (coupe) and INT-34, "Removal and Installation" (sedan). 2. Remove the front door speaker screws (A), then disconnect the front door speaker connector and remov ...

    P0138, P0158 HO2S2
    Description The heated oxygen sensor 2, after three way catalyst (manifold), monitors the oxygen level in the exhaust gas on each bank. Even if switching characteristics of the air fuel ratio (A/F) sensor 1 are shifted, the air-fuel ratio is controlled to stoichiometric, by the signal from t ...