Nissan Altima 2007-2012 Service Manual: U1001 Can comm circuit

Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.

Each control unit transmits/receives data but selectively reads required data only.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON and wait at least 3 seconds.

2. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> EC-679, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

Go to LAN-16, "Trouble Diagnosis Flow Chart".

    U0140 Can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

    P0011 IVT Control
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0011 is displayed with DTC P0075, first perform the trouble diagnosis for EC-867, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITION ...

    Other materials:

    Symptom diagnosis
    UNBALANCE STEERING WHEEL TURNING FORCE (TORQUE VARIATION) Description • Hard steering when fully turning the steering wheel. • Light steering when driving at a high speed. Diagnosis Procedure 1.CHECK SYSTEM FOR POWER SUPPLY AND GROUND Perform trouble diagnosis for power supply and gro ...

    Indicator lights
    For additional information on warnings and indicators, see “Vehicle information display” later in this section. Front fog light indicator light (if so equipped) The front fog light indicator light illuminates when the front fog lights are ON. See “Fog light switch” later in this sec ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...