Nissan Altima (L32) 2007-2012 Service Manual ≻ Power distribution system ≻ Component diagnosis ≻ U1010 control unit (CAN)

Nissan Altima (L32) 2007-2012 Service Manual: U1010 control unit (CAN)

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure

1. REPLACE BCM

When DTC U1010 is detected, replace BCM.

>> Replace BCM. Refer to BCS-96, "Removal and Installation".

U1000 can comm circuit

Description Refer to LAN-7, "System Description". DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM SELF DIAGNOSTIC 1. Turn ignition switch ON and wait for 2 second or mo ...

B2553 ignition relay

Description BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON. • Ignition relay-1 (inside IPDM E/R) • Ignition relay-2 (inside f ...

Other materials:

LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system anchor locations Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the ch ...

ProPILOT Assist (if so equipped)
WARNING Failure to follow the warnings and instructions for proper use of the ProPILOT Assist system could result in serious injury or death. ProPILOT Assist is not a self-driving system. Within the limits of its capabilities, as described in this manual, it helps the driver with certain drivin ...

Intelligent Lane Intervention (I-LI) (if so equipped)
WARNING Failure to follow the warnings and instructions for proper use of the I-LI system could result in serious injury or death. The I-LI system will not steer the vehicle or prevent loss of control. It is the driver’s responsibility to stay alert, drive safely, keep the vehicle in the tr ...