Nissan Altima Owners Manual: Using the system

Initialization

When the ignition switch is in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. When completed, the system is ready to accept voice commands. If the initialization button is pressed before the
initialization completes, the system will announce: “Voice Recognition System not ready. Please wait.”

Giving voice commands


Giving voice commands

1. Press the 2. The system announces: “Please say a category button.


2. The system announces: “Please say a category like phone or a command like points of interest followed by a brand name”. A list of available commands is then spoken by the system.

3. After the tone sounds and the face icon on the display changes, speak a command.

Available commands are discussed later in this section.

4. Voice and display feedback are provided when the command is accepted.

● If the command is not recognized, the system announces: “Command not recognized”. Repeat the command in a clear voice.

● If you want to cancel the command or go back to the previous menu of commands, press the announce: button. The system will
announce: “Cancelling voice recognition” or “Go back” depending on the current menu level.

● Press the through the menus displayed on the screen. button to move back
through the menus displayed on the screen.

● If you want to adjust the volume of the voice feedback, use the volume control switches on the steering wheel or the volume knob on the control panel.

● The voice command screen can also be accessed using the control panel display:

1. Press the [ 2. Select the “Voice Commands” key. ] button.


2. Select the “Voice Commands” key.

Operating tips

To get the best performance out of NISSAN Voice Recognition, observe the following:

● Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate the surrounding noises (traffic noises, vibration sounds, etc.), which may prevent the system from recognizing the voice commands correctly.

● Wait until a tone sounds before speaking a command. Otherwise, the command will not be received properly.

● Start speaking a command within 3.5 seconds after the tone sounds.

● Speak in a natural voice without pausing between words.

    NISSAN Voice Recognition System (if so equipped)
    The NISSAN Voice Recognition system allows hands-free operation of the systems equipped on this vehicle, such as the phone and navigation systems. To operate NISSAN Voice Recognition, press the ...

    System features
    NISSAN Voice Recognition can activate the following systems: ● Bluetooth Hands-Free Phone System ● Navigation ● Audio ● Information ● My Apps For additional info ...

    Other materials:

    Microphone signal circuit (sedan)
    Description Voice signals are transmitted from the microphone to the Bluetooth control unit using the microphone signal circuits. Diagnosis Procedure 1.CHECK HARNESS BETWEEN BLUETOOTH CONTROL UNIT AND MICROPHONE 1. Turn ignition switch OFF. 2. Disconnect Bluetooth control unit connector an ...

    Audio system (sedan)
    System Diagram System Description AUDIO SYSTEM The audio system consists of the following components • Audio unit • Window antenna • BOSE speaker amp. • Steering wheel audio control switches • Front door speakers • Tweeters • Center speaker • Rear door speakers • Re ...

    P0112, P0113 IAT sensor
    Description The intake air temperature sensor is built-into the mass air flow sensor (1). The sensor detects intake air temperature and transmits a signal to the ECM. The temperature sensing unit uses a thermistor which is sensitive to the change in temperature. Electrical resistance of the ...