Nissan Altima 2007-2012 Service Manual: Vehicle security indicator
Description
• Vehicle security indicator is built in combination meter.
• NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system conditions are indicated by blink or illumination of vehicle security indicator.
Component Function Check
1.CHECK FUNCTION
1. Perform “THEFT IND” in the “ACTIVE TEST” mode with CONSULT-III.
2. Check vehicle security indicator operation.
Is the inspection result normal? YES >> Inspection End.
NO >> Refer to SEC-124, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK COMBINATION METER
Check combination meter. Refer to MWI-4, "Work Flow".
Is the inspection result is normal? YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2.CHECK INTERMITTENT INCI
Refer to GI-42, "Intermittent Incident".
>> Inspection End.
Warning lamp
Description
• Warning lamp is built in combination meter.
• Intelligent Key system malfunction is reported to the driver by the warning
lamp illumination.
Component Function Check
1.CHECK ...
Ecu diagnosis
...
Other materials:
Fender protector
Removal and Installation
1. Fender protector
2. Fender protector side cover
A. J-clips
B. Clips
C. Center mudguard screw
a. Sheet metal nut
REMOVAL
1. Remove the engine under cover. Refer to EXT-13, "Removal and
Installation".
2. Remove the screw from center mudguard.
3 ...
B2606 steering lock relay
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2606 is displayed with DTC U1000, first per ...
B2602 shift position
Description
BCM confirms the shift position with the following 2 signals.
• CVT selector lever
• Speed signal from meter
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2602 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
SEC-433, "DTC ...