Nissan Altima manuals

Nissan Altima (L32) 2007-2012 Service Manual: Vin registration

Description

VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced.

NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M)

VIN REGISTRATION : Special Repair Requirement

1.CHECK VIN

Check the VIN of the vehicle and note it. Refer toGI-23, "Identification Number - Coupe" or GI-22, "Identification Number - Sedan".

>> GO TO 2.

2.PERFORM VIN REGISTRATION

1. Turn ignition switch ON and engine stopped.

2. Select “VIN REGISTRATION” in “WORK SUPPORT” mode.

3. Follow the instruction of CONSULT-III display.

>> END

Ignition timing
Description This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”. IGNITION TIMING : Special Repair Requirement 1.CHECK IG ...

Accelerator pedal released position learning
Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor out ...

Other materials:

P2100, P2103 throttle control motor relay
Description Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery vol ...

Precaution
HANDLING PRECAUTIONS FOR PLASTICS Precautions For Plastics 1. When repairing and painting a portion of the body adjacent to plastic parts, consider their characteristics (influence of heat and solvent) and remove them if necessary or take suitable measures to protect them. 2. Plastic par ...

Audio unit
Diagnosis Procedure 1.CHECK FUSES Check that the following fuses are not blown. Are the fuses OK? YES >> GO TO 2 NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse. 2.POWER SUPPLY CIRCUIT CHECK 1. Disconnect audio unit connector M43. ...