Nissan Altima (L32) 2007-2012 Service Manual ≻ Engine control system VQ35DE ≻ Inspection and adjustment ≻ Vin registration

Nissan Altima (L32) 2007-2012 Service Manual: Vin registration

Description

VIN Registration is an operation to register VIN in ECM. It must be performed each time ECM is replaced.

NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M).

Special Repair Requirement

1.CHECK VIN

Check the VIN of the vehicle and note it. Refer to GI-21, "Model Variation - Coupe" or GI-20, "Model Variation - Sedan".

>> GO TO 2.

2.PERFORM VIN REGISTRATION

1. Turn ignition switch ON and engine stopped.

2. Select “VIN REGISTRATION” in “WORK SUPPORT” mode.

3. Follow the instruction of CONSULT-III display.

>> END

Ignition timing

Description This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IGNITION TIMIN ...

Accelerator pedal released position learning

Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sens ...

Other materials:

Intelligent Lane Intervention (I-LI) (if so equipped)
WARNING Failure to follow the warnings and instructions for proper use of the I-LI system could result in serious injury or death. The I-LI system will not steer the vehicle or prevent loss of control. It is the driver’s responsibility to stay alert, drive safely, keep the vehicle in the tr ...

Radio
Place the ignition switch in the ACC or ON position and press the PUSHbutton to turn the radio on. If you listen to the radio with the engine not running, the ignition switch should be placed in the ACC position. Radio reception is affected by station signal strength, distance from radio transmitte ...

Fuel gauge
The gauge indicates the approximate fuel level in the tank. The gauge may move slightly during braking, turning, acceleration, or going up or down hills. The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position. The low fuel warning message shows in the vehic ...