Nissan Altima 2007-2012 Service Manual: Warning lamp

Description

• Warning lamp is built in combination meter.

• Intelligent Key system malfunction is reported to the driver by the warning lamp illumination.

Component Function Check

1.CHECK FUNCTION

1. Perform “INDICATOR” in the “Active Test” mode with CONSULT-III.

2. Check warning lamp operation.

Is the inspection result normal? YES >> Inspection End.

NO >> Refer to SEC-123, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK “COMBINATION METER.”

Check combination meter function. Refer to MWI-4, "Work Flow".

Is the inspection result is normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

    Headlamp
    Description Headlamp lighting when theft warning system is alarm phase. Component Function Check 1.CHECK HEADLAMP OPERATION Check if headlamp operate by lighting switch. Does headlamp come on ...

    Vehicle security indicator
    Description • Vehicle security indicator is built in combination meter. • NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system conditions are indicated by blink or illu ...

    Other materials:

    Measurement of weights
    Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determine axle loads. Individual axle loads should not exceed either of the gross axle weight ratings ( ...

    Power supply and ground circuit
    BCM Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuse or fusible link are blown. Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit. NO >> GO TO 2 2. CHECK POWER SUPPLY CIRC ...

    Sound signal circuit (sedan)
    SATELLITE RADIO TUNER  Description Left and right channel audio signals are supplied from the satellite radio tuner to the audio unit through the sound signal circuits. Diagnosis Procedure LEFT CHANNEL 1.CHECK HARNESS 1. Turn ignition switch OFF. 2. Disconnect satellite radio tune ...