Nissan Altima (L32) 2007-2012 Service Manual: Warning lamp
Description
• Warning lamp is built in combination meter.
• Remote keyless entry system malfunction is reported to the driver by the
warning lamp illumination.
Component Function Check
1.CHECK FUNCTION
1. Perform “INDICATOR” in the “Active Test” mode with CONSULT-III.
2. Check warning lamp operation.
Is the inspection result normal?
YES >> Inspection End.
NO >> Refer to SEC-513, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK “COMBINATION METER.”
Check combination meter function. Refer to MWI-4, "Work Flow".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> Inspection End.
Description
Headlamp lighting when theft warning system is in alarm phase.
Component Function Check
1.CHECK HEADLAMP OPERATION
Check if headlamps operate by lighting switch.
Does headlamp come ...
Description
• Vehicle security indicator is built in combination meter.
• NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system
conditions are indicated by
blink or illu ...
Other materials: I-LI system operation
Lane Departure Warning (LDW) indicator
Intelligent Lane Intervention (I-LI) indicator
(if so equipped)
ProPILOT Assist switch (for vehicles with
ProPILOT Assist)
The I-LI system operates above approximately
37 mph (60 km/h). When the vehicle
approaches either the left or the right side
of th ...
Starting the engine
1. Apply the parking brake.
2. Move the shift lever to P (Park) or N (Neutral).
P (Park) is recommended.
The starter is designed not to operate
if the shift lever is in any of the driving
positions.
3. Push the ignition switch to the ON position.
Depress the brake pedal and push
the ignition swi ...
Battery replacement
CAUTION
Be careful not to allow children to swallow
the battery or removed parts.
NISSAN Intelligent Key
Replace the battery in the Intelligent Key as
follows:
1. Remove the mechanical key from the
Intelligent Key.
2. Insert a small screwdriver A into the slit
B of the corner and twist it to separ ...