Nissan Altima Owners Manual: Warning systems switch (if so equipped)

The warning systems switch is used to temporarily


The warning systems switch is used to temporarily turn off the warning systems (Lane Departure Warning (LDW) and Blind SpotWarning (BSW) systems) that are activated using the settings menu in the vehicle information display.

When the warning systems switch is turned off, the indicator 1 on the switch is off. The indicator will also be off if all of the warning systems are deactivated using the settings menu.

The BSW system will turn on the Blind Spot indicator lights, located inside the vehicle next to the outside mirrors, if a vehicle is located in the detection zone. If the turn signal is activated in the direction of the detected vehicle, a chime sounds twice and the BSW indicator light will flash. For additional information, see “Blind Spot Warning (BSW) System / Lane DepartureWarning (LDW) System” in the “Starting and driving” section.

The LDW system will sound a warning chime and the LDW indicator light (orange) in the vehicle information display blinks to alert the driver if the vehicle is traveling close to either the left or the right of a traveling lane when detected by the camera unit. For additional information, see “Blind Spot Warning (BSW) System / Lane Departure Warning (LDW) System” in the “Starting and driving” section.

    Heated steering wheel (if so equipped)
    The heated steering wheel system is designed to operate only when the surface temperature of the steering wheel is below approximately 68°F (20°C). Push the heated steering wheel switch to w ...

    Vehicle Dynamic Control (VDC) off switch
    The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to r ...

    Other materials:

    B1150 – B1153 side curtain air bag module LH
    Description DTC B1150 – B1153 LH SIDE CURTAIN AIR BAG MODULE The LH side curtain air bag module is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the LH side curtain air bag module. PART LOCATION Refer t ...

    License lamp finisher
    Removal and Installation 1. License lamp finisher REMOVAL 1. Remove the trunk lid finisher (if equipped). Refer to INT-22, "Exploded View". 2. Remove the license lamp finisher nuts. 3. Remove license lamp finisher by pulling toward the rear, then disconnect the trunk request ...

    Fuel pressure
    Inspection FUEL PRESSURE RELEASE 1. Turn ignition switch ON. 2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode with CONSULT-III. 3. Start engine. 4. After engine stalls, crank it two or three times to release all fuel pressure. 5. Turn ignition switch OFF. 1. Rem ...