Nissan Altima Owners Manual: Windshield-washer fluid

WINDSHIELD-WASHER FLUID


WINDSHIELD-WASHER FLUID RESERVOIR

Fill the windshield-washer fluid reservoir periodically.

Add windshield-washer fluid when the low windshield-washer fluid warning light comes on.

To fill the windshield-washer fluid reservoir, lift the cap off the reservoir and pour the windshieldwasher fluid into the reservoir opening.

Add a washer solvent to the washer for better cleaning. In the winter season, add a windshield washer antifreeze. Follow the manufacturer’s instructions for the mixture ratio.

Refill the reservoir more frequently when driving conditions require an increased amount of windshield-washer fluid.

Recommended fluid is Genuine NISSAN Windshield Washer Concentrate Cleaner & Antifreeze or equivalent.

WARNING

Anti-freeze is is poisonous and should be stored carefully in marked containers out of the reach of children.

CAUTION

● Do not substitute engine anti-freeze coolant for windshield-washer fluid.

This may result in damage to the paint.

● Do not fill the windshield-washer fluid reservoir with washer fluid concentrates at full strength. Some methyl alcohol based washer fluid concentrates may permanently stain the grille if spilled while filling the windshieldwasher fluid reservoir.

● Pre-mix washer fluid concentrates with water to the manufacturer’s recommended levels before pouring the fluid into the windshield-washer fluid reservoir.

Do not use the windshield-washer fluid reservoir to mix the washer fluid concentrate and water.

    Brake fluid
    For further brake fluid specification information, refer to “Capacities and recommended fuel/lubricants” in the “Technical and consumer information” section of this manual. WARNING ● ...

    Battery
    ● Keep the battery surface clean and dry. Clean the battery with a solution of baking soda and water. ● Make certain the terminal connections are clean and securely tightened. χ ...

    Other materials:

    Clutch pedal
    Exploded View 1. Clutch pedal assembly 2. Clutch interlock switch 3. ASCD clutch switch 4. Lock nut Removal and Installation REMOVAL 1. Disconnect master cylinder rod end from clutch pedal lever. 2. Disconnect the ASCD clutch switch and clutch interlock switch harness connectors. 3. ...

    P0075, P0081 IVT control solenoid valve
    Description Intake valve timing control solenoid valve is activated by ON/OFF pulse duty (ratio) signals from the ECM. The intake valve timing control solenoid valve changes the oil amount and direction of flow via the intake valve timing control unit or stops oil flow. The longer pulse w ...

    Inspection and adjustment
    ECM RE-COMMUNICATING FUNCTION Description Performing following procedure can automatically perform re-communication of ECM and BCM, but only when the ECM has been replaced with a new one (*1). *1: New one means an ECM which has never been energized on-board. (In this step, initialization ...