Nissan Altima 2007-2012 Service Manual: B210c starter control relay

Description

Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic".

• If DTC B210C is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-37, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn the power supply position to start under the following conditions and wait for at least 1 second.

- CVT selector lever is in the P or N position.

- Depress the brake pedal

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-49, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Check “Self diagnostic result” with CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure.

See PCS-45, "DTC Index".

Is the DTC B210C displayed again? YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".

NO >> Inspection End.

    B210b starter control relay
    Description Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the ...

    B210D starter relay
    Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal ...

    Other materials:

    B2612 steering status
    Description There are 2 switches in the steering unit. IPDM E/R compares those 2 switches conditions to judge the present steering status and transmit the result to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2612 is displayed with DTC U1000, first perform th ...

    Stop lamp
    Bulb Replacement Removal 1. Remove rear combination lamp. Refer to EXL-257, "Removal and Installation". 2. Turn bulb socket counterclockwise to unlock and remove from combination lamp assembly. 3. Turn bulb counterclockwise to remove from bulb socket. Installation Installati ...

    Engine coolant temperature gauge
    System Diagram System Description The engine coolant temperature gauge indicates the engine coolant temperature. The ECM provides an engine coolant temperature signal to the combination meter via CAN communication lines. Component Parts Location 1. Combination meter M24 2. IPDM ...