Nissan Altima 2007-2012 Service Manual: Lan system can
- How to use this manual
- Precaution
- Basic inspection
- Function diagnosis
- Component diagnosis
- Can communication system
- Malfunction area chart
- Main line between dlc and abs circuit
- ECM branch line circuit
- A-bag branch line circuit
- AV Branch line circuit
- BCM branch line circuit
- DLC branch line circuit
- M&A branch line circuit
- STRG branch line circuit
- ABS branch line circuit
- TCM branch line circuit
- IPDM-E branch line circuit
- Can communication circuit
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Trouble Diagnosis Flow Chart Trouble Diagnosis Procedure INTERVIEW WITH CUSTOMER Interview with the customer is important to detect the root cause of CAN communi ...How to use this manual
HOW TO USE THIS SECTION Caution • This section describes information peculiar to a vehicle and inspection procedures. • For trouble diagnosis procedure, refer to LAN-16, "Trouble Diag ...Other materials:
BSW system operation
The BSW system operates above approximately
20 MPH (32 km/h).
When the camera unit detects vehicles in the
detection zone, the Blind spot indicator light located
inside the outside mirrors will illuminate. If
the turn signal is then activated, the system
chimes (twice) and the Blind spot i ...
P0131 A/F sensor 1
Description
The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor.
The sensor element of the A/F sensor 1 is composed an electrode
layer, which transports ions. It has a heater in the element.
The sensor is capable of precise measurement = 1, but also in the
lean and r ...
B210E starter relay
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210E is displa ...