Nissan Altima 2007-2012 Service Manual: Security control system sedan without intelligent key
- Basic inspection
- Function diagnosis
- Engine start function
- NVIS (Nissan vehicle immobilizer system- nats)
- Vehicle security system
- Diagnosis system (BCM)
- Component diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B2013 ID discord, immu-strg
- B2014 chain of strg-immu
- B2108 steering lock relay
- B2109 steering lock relay
- B210A steering lock condition switch
- B210B starter control relay
- B210C starter control relay
- B210D starter relay
- B210E starter relay
- B210F PNP/Clutch interlock switch
- B2110 PNP/Clutch interlock switch
- B2190, P1610 nats antenna amp
- B2191, P1615 Difference of key
- B2192, P1611 ID discord, immu-ecm
- B2193, P1612 chain of ECM-IMMU
- B2555 stop lamp
- B2556 push-button ignition switch
- B2557 vehicle speed
- B2560 starter control relay
- B2601 shift position
- B2602 shift position
- B2603 shift position status
- B2604 PNP switch
- B2605 PNP switch
- B2606 steering lock relay
- B2607 steering lock relay
- B2608 starter relay
- B2609 steering status
- B260B steering lock unit
- B260C steering lock unit
- B260D steering lock unit
- B260F engine status
- B2612 steering status
- B2617 starter relay circuit
- B2619 BCM
- B261A push-button ignition switch
- B26e1 no reception of engine status signal
- Power supply and ground circuit
- IPDM E/R (Intelligent power distribution module engine room)
- Key slot
- Key slot illumination
- Key cylinder switch
- Horn
- Headlamp
- Warning lamp
- Vehicle security indicator
- Ecu diagnosis
- Symptom diagnosis
- Engine start function symptoms
- Vehicle security system symptoms
- Nissan vehicle immobilizer systemnats symptoms
- On-vehicle repair
Push button ignition switch
Removal and Installation
REMOVAL
1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and
Installation".
2. Release the pawls (A) and remove the push-button ignition
switch ...
Basic inspection
...
Other materials:
DLC branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the data link connector for damage,
bend and loose connection
(connector side and harness side) ...
Locking with key
Driver’s side
Manual (if so equipped)
To lock a door, turn the key toward the front of the
vehicle 1 . To unlock, turn the key toward the rear
of the vehicle 2 .
Power (if so equipped)
The power door lock system allows you to lock or
unlock all doors at the same time.
Turning the key ...
The fuel gauge pointer does not move to "f" when
refueling
Description
The fuel gauge needle will not move to “F” position when refueling.
Diagnosis Procedure
1.OBSERVE FUEL GAUGE
Does it take a long time for the pointer to move to FULL position?
YES or NO
YES >> GO TO 2
NO >> GO TO 3
2.IDENTIFY FUELING CONDITION
Was the vehicle fue ...