Nissan Altima 2007-2012 Service Manual: Lan system can system (type 4)
COMPONENT DIAGNOSIS
- Main line between dlc and abs circuit
- ECM branch line circuit
- A-BAG branch line circuit
- AV branch line circuit
- BCM branch line circuit
- DLC branch line circuit
- M&A branch line circuit
- ABS branch line circuit
- IPDM-E branch line circuit
- Can communication circuit
- Can communication circuit
Can communication circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connect ...Main line between dlc and abs circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and co ...Other materials:
Additional service when removing battery negative terminal
Description
Initial setting is necessary when battery terminal is removed.
CAUTION:
The following specified operations are not performed under the non-initialized
condition.
• Auto-up operation
• Anti-pinch function
• Retained power operation
Special Repair Requirement
INITIALIZAT ...
On-vehicle maintenance
ENGINE COOLANT
System Inspection
WARNING:
• Never remove the radiator cap when the engine is hot. Serious burns could
occur from high pressure
coolant escaping from the radiator.
• Wrap a thick cloth around the cap. Slowly push down and turn it a quarter turn
to allow built-up pressur ...
Accelerator pedal released position
learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor output
signal. It must be performed each
time harness connector of accelerator pedal position sensor ...