Nissan Altima 2007-2012 Service Manual: SRS Airbag control system
- Basic inspection
- Function diagnosis
- SRS air bag system
- Occupant classification system
- Passenger seat belt warning system
- On board diagnostic (OBD) system
- Component diagnosis
- B1049 – B1052, B1054 – B1057 driver airbag module
- B1065 – B1068, B1070 – B1073 passenger airbag module
- B1134 – B1137 side airbag module LH
- B1129 – B1132 side airbag module RH
- B1150 – B1153 side curtain air bag module LH
- B1145 – B1148 side curtain air bag module RH
- B1086 – B1089 seat belt pre-tensioner LH
- B1081 – B1084 seat belt pre-tensioner RH
- B1033 – B1035 crash zone sensor
- B1118 – B1120 satellite sensor LH
- B1113 – B1115 satellite sensor RH
- B1xxx air bag diagnosis sensor unit
- B1023 passenger air bag off indicator
- B1017 – b1022 occupant classification system
- B1209 – b1210 collision detection
- Ecu diagnosis
- Symptom diagnosis
- Precaution
Collision diagnosis
For Frontal Collision
Check the SRS components using the following table.
• After the work is completed, perform self-diagnosis to check that no
malfunction is detected. Refer to SRC-
12, &q ...
Basic inspection
...
Other materials:
ABS branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the ABS actuator and electric unit
(control unit) for damage, bend
and loose connection (unit ...
On-vehicle maintenance
ROAD WHEEL
Inspection
ALUMINUM WHEEL
1. Check tires for wear and improper inflation.
2. Check wheels for deformation, cracks and other damage. If deformed, remove
wheel and check wheel
runout.
a. Remove tire from aluminum wheel and mount on a tire balance machine.
b. Set dial indicat ...
M&A branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the combination meter for damage, bend
and loose connection
(unit side and connector side).
...
