Nissan Altima 2007-2012 Service Manual: Defogger
- Basic inspection
- Function diagnosis
- Component diagnosis
- Rear window defogger switch
- Rear window defogger relay
- Rear window defogger power supply and ground circuit
- Driver side door mirror defogger
- Passenger side door mirror defogger
- ECU diagnosis
- Symptom diagnosis
- Rear window defogger and door mirror defogger do not operate
- Rear window defogger does not operate but both of door mirror defogger operate
- Both doors mirror defogger don’t operate but rear window defogger operates
- Driver side door mirror defogger does not operate
- Passenger side door mirror defogger does not operate
- Rear window defogger switch does not light, but rear window defogger operates
- Precaution
- On-vehicle repair
Front wiper and washer switch
Removal and Installation
NOTE:
The wiper washer switch is part of the combination switch assembly.
REMOVAL
1. Remove the spiral cable. Refer to SR-8, "Removal and Installation".
2. Di ...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1. GET INFORMATION FOR SYMPTOM
Get the detailed information from the customer about the symptom (the
condition and the ...
Other materials:
Spiral cable
Removal and Installation
REMOVAL
CAUTION:
• Before servicing, turn ignition switch OFF, disconnect both battery terminals
and wait at least three
minutes.
• Do not use air tools or electric tools for servicing.
• Do not disassemble the spiral cable.
• Do not allow oil, grease, ...
P0452 evap control system pressure
sensor
Description
The EVAP control system pressure sensor detects pressure in the
purge line. The sensor output voltage to the ECM increases as pressure
increases.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously cond ...
Front wheel hub and knuckle
Removal and Installation
1. Cotter pin
2. Disc rotor
3. Wheel hub and bearing assembly
4. Splash guard
5. Steering knuckle
REMOVAL
1. Remove wheel and tire from vehicle. Refer to WT-66, "Adjustment".
2. Remove brake caliper using power tool, leaving brake caliper hydraulic li ...