Nissan Altima 2007-2012 Service Manual: Charging system
- Basic inspection
- Function diagnosis
- Component diagnosis
- Charging system preliminary inspection
- Power generation voltage variable control system operation inspection
- B Terminal circuit
- L Terminal circuit
- S Terminal circuit
- Charging system
- Symptom diagnosis
- Precaution
- Preparation
- On-vehicle repair
- Service data and specifications (SDS)
Push button ignition switch
Removal and Installation
REMOVAL
1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and
Installation".
2. Release the pawls (A) and remove the push-button ignition
switc ...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
NOTE:
To ensure a complete and thorough diagnosis, the battery, starter and generator
test segments must be done
as a ...
Other materials:
P0455 Evap control system
DTC Logic
DTC DETECTION LOGIC
This diagnosis detects a very large leakage (fuel filler cap fell off etc.)
in EVAP system between the fuel tank
and EVAP canister purge volume control solenoid valve.
CAUTION:
• Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect
...
Service data and specifications(SDS)
Wheel Alignment (Unladen*)
Fuel, radiator coolant and engine
oil full. Spare tire, jack, hand tools and mats in designated positions.
Fuel,
radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in
designated positions.
Ball Joint
Wheelarch Height (Unladen*1) ...
Water control valve
Removal and Installation
1. Thermostat
2. O-ring
3. Engine coolant inlet
4. Water control valve
5. Gasket
6. Engine coolant outlet
7. Copper washer
8. Engine coolant temperature sensor
9. Heater pipe
A. To electric throttle control
B. To oil cooler
C. To heater
D. To heater
E. To ele ...