Nissan Altima 2007-2012 Service Manual: Engine mechanical
- Precaution
- Preparation
- Function diagnosis
- On-vehicle maintenance
- On-vehicle repair
- Air cleaner and air duct
- Intake manifold
- Exhaust manifold and three way catalyst
- Oil pan and oil strainer
- Ignition coil
- Fuel injector and fuel tube
- Rocker cover
- Camshaft
- Timing chain
- Oil seal
- Cylinder head
- Disassembly and assembly
- Service data and specifications (SDS)
- Precaution
- Preparation
- Function diagnosis
- On-vehicle maintenance
- On-vehicle repair
- Air cleaner and air duct
- Intake manifold collector
- Intake manifold
- Exhaust manifold and three way catalyst
- Oil pan and oil strainer
- Ignition coil
- Fuel injector and fuel tube
- Rocker cover
- Front timing chain case
- Timing chain
- Rear timing chain case
- Camshaft
- Oil seal
- Cylinder head
- Removal and installation
- Disassembly and assembly
- Service data and specifications (SDS)
Consult-iii checking system
Description
• When CONSULT-III is connected with a data link connector
equipped on the vehicle side, it will communicate with the control
unit equipped in the vehicle and then enable various ki ...
Precaution
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...
Other materials:
Vehicle security system
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
OPERATION FLOW
SETTING THE VEHICLE SECURITY SYSTEM
Initial Condition
• Ignition switch is in OFF position.
Disarmed Phase
• When doors or trunk is open, the vehicle security system is set in the
disarmed phase on the a ...
Memory function does not operate
Diagnosis Procedure
SYMPTOM: Memory function does not operate. The setting is not maintained (it
returns to the initial condition).
Inspection procedure
1.CHECK OPERATION
1. Set temperature control dial to 32°C (90°F).
2. Press OFF switch.
3. Press ignition switch OFF.
4. Press ig ...
P0117, p0118 ect sensor
Description
The engine coolant temperature sensor is used to detect the engine
coolant temperature. The sensor modifies a voltage signal from the
ECM. The modified signal returns to the ECM as the engine coolant
temperature input. The sensor uses a thermistor which is sensitive to
the change i ...