Nissan Altima 2007-2012 Service Manual: Exterior lighting system
- Basic inspection
- Function diagnosis
- Headlamp (xenon type)
- Headlamp (halogen type)
- Daytime running light system
- Auto light system
- Front fog lamp
- Turn signal and hazard warning lamps
- Parking, license plate and tail lamps
- Combination switch reading system
- Diagnosis system (BCM)
- Diagnosis system (IPDM E/R)
- Component diagnosis
- Power supply and ground circuit
- Headlamp (HI) circuit
- Headlamp (LO) circuit
- Front fog lamp circuit
- Parking lamp circuit
- Turn signal lamp circuit
- Optical sensor
- Headlamp (halogen)
- Headlamp (xenon)
- Daytime running light system
- Auto light system
- Front fog lamp system
- Turn signal and hazard warning lamp system
- Parking, license plate and tail lamps system
- Stop lamp
- Back-up lamp
- ECU diagnosis
- Symptom diagnosis
- Exterior lighting system symptoms
- Normal operating condition
- Both side headlamps do not switch to high beam
- Both side headlamps (LO) are not turned on
- Parking, license plate and tail lamps are not turned on
- Both side front fog lamps are not turned on
- Precaution
- On-vehicle maintenance
- On-vehicle repair
- Headlamp
- Front fog lamp
- Stop lamp
- Back-up lamp
- License plate lamp
- Rear combination lamp
- Lighting and turn signal switch
- Hazard switch
- Service data and specifications (SDS)
Disassembly and assembly
DOOR MIRROR
Exploded View
1. Door mirror cover
2. Mirror housing assembly
3. Mirror glass and holder
Disassembly
1. Turn the mirror glass surface upward.
2. Apply a protective tape (A) to ...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Find out what the customer's concerns are.
>> GO TO 2
2.SYMPTOM CHECK
Verify the s ...
Other materials:
Headlamp
CONSULT-III Function
WORK SUPPORT
1 : Initial setting
2: With auto light system
DATA MONITOR
1: With auto light system.
2: The item is indicated, not monitored.
ACTIVE TEST
...
Malfunction indicator lamp
Description
The Malfunction Indicator Lamp (MIL) is located on the combination
meter.
The MIL will light up when the ignition switch is turned ON without
the engine running. This is a bulb check.
When the engine is started, the MIL should go off. If the MIL remains
on, the on board diagno ...
Spiral cable
Removal and Installation
REMOVAL
CAUTION:
• Before servicing, turn ignition switch OFF, disconnect both battery terminals
and wait at least three
minutes.
• Do not use air tools or electric tools for servicing.
• Do not disassemble the spiral cable.
• Do not allow oil, grease, ...